Products

HP J8705A ProCurve Switch 5400zl 20p 10/100/1000 + 4p Mini-GBIC Module These modules have baeen pulled from a 5400 series HP switch and have been tested and are fully functional. They have 24-ports, gigabit and POE. A 3mth warranty is provided for your peace of mind.

The 4-port (NM-4A/S) and 8-port (NM-8A/S) asynchronous/synchronous (async/sync) network modules provide async connectivity with speeds up to 115.2 kbps, and sync connectivity with speeds up to 128 kbps. These modules use the 60-pin "5-in-1" cables, similar to those used on the Cisco 2500 and Cisco 7000 series routers.

Cisco MDS 9216i integrates both Fibre Channel and IP storage services in a single system to allow maximum flexibility in user configurations. With 14 2-Gbps Fibre Channel ports, two Gigabit Ethernet IP storage services ports, and a modular expansion slot, the Cisco MDS 9216i is ideally suited for enterprise storage networks that require high-performance SAN extension or cost-effective IP storage connectivity.

The Nortel Ethernet Routing Switch 4524T is a stackable system that provides the high-performance, convergence-ready, secure and resilient Ethernet switching connectivity required by today's application and competition-driven enterprise networks. The Ethernet Routing Switch 4524T delivers 10/100 and 10/100/1000 switching. NOTE: NO CABLES ARE INCLUDED WITH THIS ITEM. THIS LISTING IS FOR THE SWITCH ONLY.

The 220 V ac Power Supply module converts alternating current (AC) into direct current (DC) and distributes power to the backplane and to all the modules in the chassis. Each module includes status indicators and a power connector. When using the 220 V ac Power Supply module, circuit protection must be supplied by the customer. In a redundant configuration, two Power Supply modules operate in a load-sharing mode to increase system reliability. This configuration ensures that as long as one Power Supply module is active, all other modules are fully powered. When two Power Supply modules are installed, each normally runs at one-half of its capacity. If one Power Supply module fails, the other module takes over completely.